4 修訂歷史記錄
Changes from D Revision (May 2012) to E Revision
- Deleted 刪除了封裝/訂購信息 表；請參閱數(shù)據(jù)表末尾的封裝選項附錄Go
- Deleted ESD specifications from Absolute Maximum Ratings table. Moved to separate ESD Ratings table.Go
- Deleted references to Tx PGA calibration in Calibration ModesGo
- Deleted reference to TX_PGA_CAL in Table 14Go
Changes from C Revision (March 2012) to D Revision
Changes from B Revision (September 2011) to C Revision
- Changed 更 改 了說明 部分的變送功率放大器工作范圍說明Go
- Added cross-reference to footnote 2 to Output short-circuit (PA) parameter in Absolute Maximum Ratings tableGo
- Changed Frequency Response, Passband frequency (B/C/D Modes) parameter minimum and typical specifications in Electrical Characteristics: Receiver (Rx)Go
- Deleted Digital Outputs (INT, Tx_Flag, Rx_Flag), INT pin high, INT pin low, Tx_Flag high, Tx_Flag low, Rx_Flag high, and Rx_Flag low parameter units from Electrical Characteristics: DigitalGo
- Changed Digital Outputs (INT, Tx_Flag, Rx_Flag), Tx_Flag high, Tx_Flag low, Rx_Flag high, and Rx_Flag low parameter specification descriptions in Electrical Characteristics: DigitalGo
- Changed Operating Supply Range, Power amplifier supply voltage parameter maximum specification in Electrical Characteristics: Power SupplyGo
- Changed title of Figure 20Go
- Changed description of PA operating range in PA Block sectionGo
- Updated Equation 2Go
- Changed proper design margin note in PA Block sectionGo
- Updated Figure 34Go
- Changed description of REF1 and REF2 Blocks sectionGo
- Changed second paragraph of Power Supplies sectionGo
- Changed title of Table 11Go